相关文章
友情链接

卧式包装机常见故障分析及维修方法

卧式包装机

使用捆扎带缠绕产品或包装件,然后收紧并将两端通过热效应熔融或使用包扣等材料连接的机器,使塑料带

能紧贴于被捆扎包件表面,保证包件在运输、贮存中不因捆扎不牢而散落,同时还应捆扎整齐美观。

Horizontal packaging machine straps wrapped product or package, and then tighten the two ends are connected

by thermal effects such as melting or use package buckle material of the machine, the plastic belt can be

tied closely to the surface of the package to ensure that the package in transportation, storage is not a

result of bundling is not strong and scattered, while also tying neat appearance.

虽然卧式包装机耐用性卓越,但随着时间的流逝,机械的磨损,大型打包机还是会出现一些故障,以下为大家简析一下

While horizontal packaging machine durability of excellence, but with the passage of time, mechanical wear,

large balers or will be some failures, the following is what we Brief common Horizontal Baler maintenance

螺丝,由于此两个螺丝固定在连接轴心的缺口部分,所以必须将螺丝转上些;取下连接轴心,将上轮机拿起,取出卡住物。

Cassette handling: When the tape stuck in the middle of the wheel, or a foreign body plug can not be removed,

disassembled hex nut washer, loosen the middle connecting the two M5 countersunk head screws on the axis,

since the two screws in the connection notch axis, it must turn the screws on some; remove the connection

axis, the turbine will pick up, remove the jammed matter.

擦掉油;3.皮带太紧,将皮带传动座往下下调些,或将马达往后调些即可。

After a large baler tied tight with no cut: There are many situations can cause this situation, such as: an

elastic adjustment too tight; 2 slip sheet or skid belt with oil, wipe the oil must be removed; 3 belt too

tight.. , will cut down some of the seat belt drive, or some can tune the motor back.

卧式包装机